SUBARU impreza SERVICE and USER MANUAL

SECURITY AND LOCKS

Sort by: default name
Trunk Opener Button REMOVAL Trunk Opener Button REMOVAL SECURITY AND LOCKS > Trunk Opener Button REMOVAL 1. Disconnect the ground cable from battery. NOTE 2. Remove the garnish - trunk. Trunk Lid Garnish > REMOVAL 3. Release the locks at both ends of the trunk...
Trunk Lid Latch and Actuator Assembly INSPECTION Trunk Lid Latch and Actuator Assembly INSPECTION SECURITY AND LOCKS > Trunk Lid Latch and Actuator Assembly INSPECTION 1. LATCH Check if the latch operates normally. If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the lock assembly...
Trunk Lid Latch and Actuator Assembly REMOVAL Trunk Lid Latch and Actuator Assembly REMOVAL SECURITY AND LOCKS > Trunk Lid Latch and Actuator Assembly REMOVAL 1. Disconnect the ground cable from battery. NOTE NOTE: For the 12 volt engine restart battery of HEV model, disconnect the ground terminal from 12V...
Steering Lock CM REMOVAL Steering Lock CM REMOVAL SECURITY AND LOCKS > Steering Lock CM REMOVAL 1. Disconnect the ground cable from battery. NOTE NOTE: For the 12 volt engine restart battery of HEV model, disconnect the ground terminal from 12V engine restart...
Starter Relay (Push Button Start) REMOVAL Starter Relay (Push Button Start) REMOVAL SECURITY AND LOCKS > Starter Relay (Push Button Start) REMOVAL 1. Remove the cover assembly - instrument panel LWR driver and the knee airbag module. Knee Airbag Module > REMOVAL 2. Release the lock and remove the...
Starter Cut Relay REMOVAL Starter Cut Relay REMOVAL SECURITY AND LOCKS > Starter Cut Relay REMOVAL 1. Remove the cover assembly - instrument panel LWR driver and the knee airbag module. Knee Airbag Module > REMOVAL 2. Release the lock and remove the fuse holder....
Security Control Module REMOVAL Security Control Module REMOVAL SECURITY AND LOCKS > Security Control Module REMOVAL 1. Remove the heater and cooling unit assembly. Heater and Cooling Unit > REMOVAL 2. Remove the security control module. (1) Disconnect the connector....
Remote Openers REMOVAL Remote Openers REMOVAL SECURITY AND LOCKS > Remote Openers REMOVAL 1. FRONT HOOD OPENER 1. Remove the opener handle. (1) Remove the cable. (2) Remove the bolt, and remove the opener handle. 2. Remove the following parts...
Relay and Fuse INSPECTION Relay and Fuse INSPECTION SECURITY AND LOCKS > Relay and Fuse INSPECTION 1. CHECK FUSE 1. Remove the fuse and inspect visually. 2. If the fuse is blown out, replace the fuse. NOTE: If the fuse is blown again, check the system wiring...
Relay and Fuse LOCATION Relay and Fuse LOCATION SECURITY AND LOCKS > Relay and Fuse LOCATION Main fuse box Fuse 15 A (turn signal and hazard unit, body integrated unit) (A) Fuse 20 A (body integrated unit, immobilizer antenna) (B) Relay &...
Receiver REMOVAL Receiver REMOVAL SECURITY AND LOCKS > Receiver REMOVAL NOTE: Except for model with keyless entry 1. 4 DOOR MODEL 1. Disconnect the ground cable from battery. NOTE 2. Remove the trim panel assembly - rear shelf. Rear Shelf...
Rear Outer Handle REMOVAL Rear Outer Handle REMOVAL SECURITY AND LOCKS > Rear Outer Handle REMOVAL 1. Raise the glass assembly - rear door to the top position. 2. Remove the trim panel - rear door. Door Trim > REMOVAL 3. Remove the sealing cover - rear door....
Rear Lock Button REMOVAL Rear Lock Button REMOVAL SECURITY AND LOCKS > Rear Lock Button REMOVAL NOTE: The rear lock button is integrated into the rear gate opener button. 1. Remove the garnish assembly - rear gate. Rear Gate Garnish > REMOVAL 2. Remove the...
Rear Inner Remote REMOVAL Rear Inner Remote REMOVAL SECURITY AND LOCKS > Rear Inner Remote REMOVAL 1. Remove the trim panel - rear door. Door Trim > REMOVAL 2. Remove the screw, and remove the remote assembly - door.
Rear Gate Opener Button INSPECTION Rear Gate Opener Button INSPECTION SECURITY AND LOCKS > Rear Gate Opener Button INSPECTION UNIT INSPECTION Preparation tool: Circuit tester 1. Check the resistance between switch terminals. Terminal No. Inspection conditions Standard...
Rear Gate Opener Button REMOVAL Rear Gate Opener Button REMOVAL SECURITY AND LOCKS > Rear Gate Opener Button REMOVAL NOTE: • The button - opener rear gate is integrated with the rear lock button. (Model with keyless access) • Before disconnecting the battery ground...
Rear Gate Latch and Actuator Assembly INSPECTION Rear Gate Latch and Actuator Assembly INSPECTION SECURITY AND LOCKS > Rear Gate Latch and Actuator Assembly INSPECTION 1. LATCH Check if the latch operates normally. If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the latch and...
Rear Gate Latch and Actuator Assembly REMOVAL Rear Gate Latch and Actuator Assembly REMOVAL SECURITY AND LOCKS > Rear Gate Latch and Actuator Assembly REMOVAL 1. Disconnect the ground cable from battery. NOTE NOTE: For the 12 volt engine restart battery of HEV model, disconnect the ground terminal from 12V...
Rear Door Latch and Door Lock Actuator Assembly INSPECTION Rear Door Latch and Door Lock Actuator Assembly INSPECTION SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator Assembly INSPECTION 1. LATCH Check if the latch operates normally. If the cable is faulty, replace the latch & actuator assembly - rear. 2. ACTUATOR UNIT...
Rear Door Latch and Door Lock Actuator Assembly REMOVAL Rear Door Latch and Door Lock Actuator Assembly REMOVAL SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator Assembly REMOVAL 1. Disconnect the ground cable from battery. NOTE NOTE: For the 12 volt engine restart battery of HEV model, disconnect the ground...
Push Button Ignition Switch INSPECTION Push Button Ignition Switch INSPECTION SECURITY AND LOCKS > Push Button Ignition Switch INSPECTION On the vehicle inspection Preparation tool: Circuit tester 1. Check the continuity between push button ignition switch terminals. Terminal No....
Push Button Ignition Switch REMOVAL Push Button Ignition Switch REMOVAL SECURITY AND LOCKS > Push Button Ignition Switch REMOVAL 1. Remove the cover assembly - instrument panel LWR driver and the knee airbag module. Knee Airbag Module > REMOVAL 2. Remove the push button ignition...
Key Lock Cylinders REPLACEMENT Key Lock Cylinders REPLACEMENT SECURITY AND LOCKS > Key Lock Cylinders REPLACEMENT 1. STEERING LOCK 1. Disconnect the ground cable from battery. NOTE NOTE: For the 12 volt engine restart battery of HEV model, disconnect the ground terminal...
Keyless Transmitter INSPECTION Keyless Transmitter INSPECTION SECURITY AND LOCKS > Keyless Transmitter INSPECTION 1. KEYLESS TRANSMITTER BATTERY 1. Check the keyless transmitter battery voltage. PREPARATION TOOL: Circuit tester NOTE: Complete the measurement within 5...